- 您现在的位置：买卖IC网 > Sheet目录311 > AS3642-ZWLT (ams)IC WHITE LED FLASH DRIVER 6WLCSP
AS3642
Datasheet - D e t a i l e d D e s c r i p t i o n
Figure 19. Device Shutdown and Wakeup
" &
" #!$%"
! !"
AS3642
! !"
$
' ( )(*
)) ) (
+ & +
The AS3642 supports the I C bus protocol. A device that sends data onto the bus is defined as a transmitter and a
the I C bus. Within the bus specifications a standard mode (100kHz maximum clock rate) and a fast mode (400kHz
I 2 C Serial Data Bus
2
device receiving data as a receiver. The device that controls the message is called a master. The devices that are
controlled by the master are referred to as slaves. A master device that generates the serial clock (SCL), controls the
bus access, and generates the START and STOP conditions must control the bus. The AS3642 operates as a slave on
2
maximum clock rate) are defined. The AS3642 works in both modes. Connections to the bus are made through the
open-drain I/O lines SDA and SCL.
The following bus protocol has been defined ( Figure 20 ):
?? Data
transfer may be initiated only when the bus is not busy.
?? During
data transfer, the data line must remain stable whenever the clock line is HIGH. Changes in the data line
while the clock line is HIGH are interpreted as control signals.
Accordingly, the following bus conditions have been defined:
Bus Not Busy
Both data and clock lines remain HIGH.
Start Data Transfer
A change in the state of the data line, from HIGH to LOW, while the clock is HIGH, defines a START condition.
Stop Data Transfer
A change in the state of the data line, from LOW to HIGH, while the clock line is HIGH, defines the STOP condition.
Data Valid
The state of the data line represents valid data when, after a START condition, the data line is stable for the duration of
the HIGH period of the clock signal. The data on the line must be changed during the LOW period of the clock signal.
There is one clock pulse per bit of data.
Each data transfer is initiated with a START condition and terminated with a STOP condition. The number of data bytes
transferred between START and STOP conditions are not limited, and are determined by the master device. The
information is transferred byte-wise and each receiver acknowledges with a ninth bit.
www.austriamicrosystems.com/AS3642
1.2-2
12 - 26
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
AS3643-ZWLT
IC LED DVR CAMERA FLASH 13WLCSP
AS3647-ZWLT
IC LED DVR 1600MA FLASH 13WLCSP
AS3648-ZWLT-500
IC WHITE LED FLASH DVR 13WLCSP
AS3665-ZWLT
IC LED DRIVER SMARTLIGHT 25WLCSP
AS3685B-T
IC DVR PHOTOFLASH 1A 10-DFN
AS3685C-T
IC DVR PHOTOFLASH 1A 10-DFN
AS3691B-ZMFT
IC LED DVR 400MA RGB/WHT 64-MLF
AS3691B-ZTSP
IC LED DVR 400MA RGB/WH 20ETSSOP
相关代理商/技术参数
AS3642-ZWLT-500
功能描述:IC WHITE LED FLASH DRIVER 6WLCSP RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 特色产品:LM3445 TRIAC Dimmable LED Driver 标准包装:55 系列:PowerWise® 恒定电流:是 恒定电压:- 拓扑:PWM，降压（降压） 输出数:1 内部驱动器:无 类型 - 主要:- 类型 - 次要:高亮度 LED（HBLED） 频率:30kHz ~ 1MHz 电源电压:8 V ~ 12 V 输出电压:- 安装类型:表面贴装 封装/外壳:14-SOIC（0.154"，3.90mm 宽） 供应商设备封装:14-SOICN 包装:管件 工作温度:-40°C ~ 125°C 产品目录页面:1285 (CN2011-ZH PDF) 其它名称:LM3445M
AS3643-ZWLT
功能描述:IC LED DVR CAMERA FLASH 13WLCSP RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极，PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND
AS3643-ZWLT-500
功能描述:IC WHITE LED FLASH DVR 13WLCSP RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 特色产品:LM3445 TRIAC Dimmable LED Driver 标准包装:55 系列:PowerWise® 恒定电流:是 恒定电压:- 拓扑:PWM，降压（降压） 输出数:1 内部驱动器:无 类型 - 主要:- 类型 - 次要:高亮度 LED（HBLED） 频率:30kHz ~ 1MHz 电源电压:8 V ~ 12 V 输出电压:- 安装类型:表面贴装 封装/外壳:14-SOIC（0.154"，3.90mm 宽） 供应商设备封装:14-SOICN 包装:管件 工作温度:-40°C ~ 125°C 产品目录页面:1285 (CN2011-ZH PDF) 其它名称:LM3445M
AS3644-ZWLT
功能描述:LED 驱动器 IC 1 输出 DC DC 稳压器 升压（升压） I2C 调光 320mA（闪存） 6-WLCSP（1.5x1.1） 制造商:ams 系列:- 包装:带卷（TR） 零件状态:有效 类型:DC DC 稳压器 拓扑:升压（升压） 内部开关:是 输出数:1 电压 - 供电（最低）:2.5V 电压 -?供电（最高）:5V 电压 - 输出:- 电流 - 输出/通道:320mA（闪存） 频率:4MHz 调光:I2C 应用:照相机闪光灯 工作温度:-30°C ~ 85°C（TA） 安装类型:表面贴装 封装/外壳:6-UFBGA，WLCSP 供应商器件封装:6-WLCSP（1.5x1.1） 标准包装:12,000
AS3645A-ZWLT
制造商:ams 功能描述:IC PHOTOFLASH DRIVER 12WLCSP 制造商:ams 功能描述:T&R / WL-CSP12 (2.0x1.5x0.5)
AS3645-ZWLT
功能描述:IC PHOTOFLASH DRIVER 12WLCSP RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program 标准包装:2,500 系列:- 恒定电流:- 恒定电压:- 拓扑:升压（升压），切换式电容器（充电泵） 输出数:1 内部驱动器:是 类型 - 主要:背光 类型 - 次要:白色 LED 频率:625kHz ~ 875kHz 电源电压:2.7 V ~ 5.3 V 输出电压:5V 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽） 供应商设备封装:10-µMAX 包装:带卷 (TR) 工作温度:-40°C ~ 85°C
AS3646-ZWLT
功能描述:IC LED DRIVER REGULATOR 12WLCSP 制造商:ams 系列:* 零件状态:有效 标准包装:500
AS3647B-ZWLT
功能描述:LED 驱动器 IC 2 输出 DC DC 稳压器 升压（升压） I2C 调光 800mA（闪存） 15-WLCSP 制造商:ams 系列:- 包装:带卷（TR） 零件状态:有效 类型:DC DC 稳压器 拓扑:升压（升压） 内部开关:是 输出数:2 电压 - 供电（最低）:2.7V 电压 -?供电（最高）:4.4V 电压 - 输出:2.8 V ~ 5.5 V 电流 - 输出/通道:800mA（闪存） 频率:4MHz 调光:I2C 应用:照相机闪光灯 工作温度:-30°C ~ 85°C（TA） 安装类型:表面贴装 封装/外壳:15-UFBGA，WLCSP 供应商器件封装:15-WLCSP 标准包装:10,000